Active ingredients: N-Alkyl (60% C14, 30% C16, 5% C12, 5% C18). Dimethyl Benzyl Ammonium Chlorides - 0.0125%. N-Alkyl (68% C12, 32% C14). Dimethyl Ethylbenzyl Ammonium Chlorides - 0.0125%. Other ingredients - 99.9750%. Total - 100.0000%.
Directions for use: it is a violation of federal law to use this product in a manner inconsistent with its labeling. Shake well before using. General cleaning: Hold can upright and spray about eight inches from surface. See picture at right. Wipe with soft clean cloth for best results. If using on electronic equipment, spray product directly onto cloth then dust as usual. To sanitize hard, non-porous surfaces: spray until thoroughly wet. Let stand 30 seconds. Then wipe. For heavily soiled areas or surfaces, a precleaning is required. To disinfect hard, non porous surfaces: spray until thoroughly wet. Allow surface to remain wet for 7 minutes. Then wipe. For heavily soiled areas or surfaces a precleaning is required. Not for use on food contact surfaces. Note: unplug electrical appliances before using. Not suitable for unsealed wood, marble, or granite surfaces. Spot test all other surfaces in an inconspicuous area. Storage and disposal: Storage: store in a cool, dry place away from heat or flame. Disposal: This container may be recycled where aerosol can recycling is available. Before offering for recycling, empty the can by using the product according to the label. If recycling is not available, discard empty container in trash. Physical or chemical hazards: contents under pressure. Do not use or store near heat or open flame. Do not puncture or incinerate container. Exposure to temperatures above 130 degrees F (54 degrees C) may cause bursting.