Read instructions before using. 1. Protect work area. Glue may damage fabrics and furniture finishes. 2. Remove glue tube from case. Hold upright and point away from eyes and body. 3. Insert pin in tip of tube. If glue clogs at tip, pierce again with pin. Always point away from eyes and body before removing pin. 4. Parts to be glued should be clean and dry. Parts must mate. Metals may have to be cleaned with a solvent or scraped. Dampen porous ceramics on one side and apply glue to dry side. 5. Gently squeeze a small drop of glue on one side of part. Apply one drop per square inch. Too much glue or spreading glue will make a poor bond or no bond. 6. Join the parts and press for 30 seconds. Allow to set for a few minutes. 7. Insert pin in tip of tube. Store upright in capped case. Not for use on foam, rear view mirrors, polyethylene, or fluorinated resin. Do not put bonded items in oven or on stove. Do not use to attach artificial nails. Store in a cool, dark place.
Elmer's Products, Inc.
Columbus, OH 43219
Eye and skin irritant. Bonds skin instantly. Contains ethyl cyanoacrylate. Avoid contact with skin and eyes. If eye or mouth contact occurs, hold eyelid or mouth open and rinse thoroughly but gently with water only for 15 minutes and get medical attention. Liquid glue will sting eye temporarily. Solidified glue may irritate eye like a grain of sand and should be treated by an eye doctor. If skin bonding occurs, soak in acetone-based nail polish remover or warm soapy water and carefully peel or roll skin apart (do not pull). Contact through clothing may cause skin burn. If spilled on clothing, flush with cold water. Avoid prolonged breathing of vapors. Use with adequate ventilation. Keep out of reach of children.