Ingredients: Water, Cetearyl Alcohol, 1,2,4-Trihydroxybenzene, Steareth-21, Toluene-2,5-Diamine, Ethanolamine, Ceteareth-20, Hydroxyethyl Cellulose, m-Aminophenol, p-Phenylenediamine, Fragrance, N,N-Bis(2-Hydroxyethyl)-P-Phenylenediamine Sulfate, 2-Amino-4-Hydroxyethylaminoanisole Sulfate, 2,4-Diaminophenoxyethanol Sulfate, p-Aminophenol, Manganese Sulfate, Erythorbic Acid, Sodium Sulfite, Etidronic Acid.
Important: follow usage advisory on the side panel. Easy step-by-step directions. Preparation. What you need. Timer, clock or watch. Old shirt (to cover you against stains). Old towels (to cover counters to protect against stains). Damp paper towel (to wipe skin if haircolour gets on it). Shampoo. Cover countertops. Put on the gloves, then, remove the cap from the end of the tube and peel off the seal; immediately screw on the comb applicator to prevent the product from oxidizing. Application. You have the choice of two ways to apply, depending on how much grey you have. In both cases, apply to dry hair. Do not wash hair right before applying. Option 1: if you have a lot of grey (full head application). Apply to hair: Squeeze tube gently until you see a small amount of product come out between the teeth of the applicator. During application, continue to squeeze the tube to ensure an even flow of product. Start where hair is greyest, then comb product through evenly from front to back of head and from side to side using the comb applicator to spread. If the applicator does not work well for your hair type or length, just work product through hair with gloved hands or on your own comb. Make sure all your hair is thoroughly combed through. Don t forget the back and sides! Wait 10 minutes. The product will be instantly activated by oxygen in the air. The colour of the product will turn very dark; this is normal and has nothing to do with the colour you will get with Just For MenÂ® AutoStopâ„¢. Start timing yourself after application is completed. Use timer, clock or watch. Wait at least 10 minutes. Don't worry if you leave the product on longer because it will not turn darker with more time. If you like, use the 10 minutes to clean up/check for any haircolour on skin and wipe away. Rinse & shampoo. In shower, rinse hair thoroughly with warm water until water runs clear. Shampoo and rinse again. If you do see colour rub off on your towel, shampoo and rinse twice after you use Just For MenÂ® AutoStopâ„¢. When colour is completely rinsed out it will not stain. Re-apply once every 4 to 6 weeks when grey roots become visible. Option 2: if you have a little grey-or-grey in concentrated areas (no need to colour all your hair). Apply to hair. Squeeze tube gently until you see a small amount of product come out between the teeth of the applicator. During the application, continue to squeeze the tube to ensure an even flow of product. Only apply to the areas that are grey. If the applicator does not work well for your hair type or length, just work product through hair with your gloved hands or use your own comb. Wait 10 minutes. Same as option 1 above. Final step: rinse & shampoo. Same as option 1 above.