Follow instructions carefully! Save instructions for clean removal in the future! To Apply: 1. Clean surface. Clean the surface with isopropyl rubbing alcohol, wipe gently, let dry. Do not use household cleaners. 2 Apply strip to clip. Remove red liner. Position strip on back of clip and press firmly. 3. Press firmly. Remove black wall side liner . Position clip and press firmly for 30 seconds. 4. Wait 1 hour before inserting cord(s). 5. Insert cord(s). Place cord(s) inside clip. Hook latch to close. To Remove: 1 Remove cord(s). Unlock latch and remove cord(s). 2. Grab removal tab. Never pull the strip out at an angle. Strip could break or damage surface. To prevent clip from snapping your fingers, hold clip as shown. Do not press clip against the surface. 3. Slowly slide the tab straight against the surface, stretching at least 6 inches (15 cm) until the clip releases. Note: Apply to surfaces above 50 degrees F (10 degrees C). Adhesive could soften and lose adhesion above 105 degrees F (40 degrees C).
P.O. Box 33053 St. Paul, MN 55133-3053