Close this window
Click the store of your choice to purchase 3M Cord Bundlers with Command Adhesive:

Cord Bundlers with Command Adhesive



2.00 ct
SKU / UPC: 051131830493


Follow instructions carefully! Save instructions for clean removal in the future! To Apply: 1. Clean surface. Clean the surface with isopropyl rubbing alcohol, wipe gently, let dry. Do not use household cleaners. 2. Apply strip to bundler. Remove red liner. Position strip on back of clip and press firmly. 3. Press firmly. Remove black wall side liner. Position clip and press firmly for 30 seconds. 4. Wait 1 hour before use. 5. Mount cord(s). Lift bundler strap to open. Place cord(s) over bundler strap. Close bundler strap. To Remove: 1. Remove cord(s). Lift strap upward and away from base to open. 2. Grab removal tab. Lift strap upward to reveal tab. Never pull the strip out at an angle. Strip could break or damage surface. To prevent bundler from snapping your fingers, hold bundler as shown. Do not press bundler against the surface. 3. Slowly slide the tab straight against the surface, stretching at least 6 inches (15 cm) until the bundler releases. Note: Apply to surfaces above 50 degrees F (10 degrees C). Adhesive could soften and lose adhesion above 105 degrees F (40 degrees C).

Other Info



P.O. Box 33053 St. Paul, MN 55133-3053