To Apply: 1. Clean surface with isopropyl rubbing alcohol, wipe gently, let dry. Do not use household cleaners. Separate strips. 2. Remove red liner. Press adhesive to hook. 3. Remove black liner. 4. Press to surface for 10 seconds. 5. Important: For maximum holding strength slide hook off. 6. And press base firmly for 30 seconds. 7. Slide hook on. 8. Wait 1 hour before use. To Remove: 1. Slide hook up to remove from mounting base. 2. Never pull strip towards you. 3. Hold base gently to prevent base from snapping fingers. Do not press base against wall. 4. Stretch straight down along wall at least 12 inches until base and strip release. Note: Apply to surfaces above 50 degrees F (10 degrees C). Adhesive could lose adhesion above 105 degrees F (40 degrees C). Not intended for picture hanging. Instead use Command Picture Hanging Strips, Sawtooth or Wire-Backed Hangers. Hooks can be reused with Command Small Strips.
St. Paul, MN 55144-1000
Important: Failure to follow instructions carefully may cause damage! Save instructions for damage-free removal or visit command.com. Do not use with wallpaper. May not adhere well to vinyl surfaces. Do not use for antiques, heirlooms, or other valuable or irreplaceable items. Do not hang items over beds. Use only one hook per item hung.