Important: Follow instructions carefully! Save instructions for clean removal in the future! To Apply: 1. Clean surface with isopropyl rubbing alcohol, wipe gently, let dry. Do not use household cleaners. 2. Separate strips at perforation. Connect fasteners by pressing firmly together until they snap. 3. Remove one liner. Position on set of strips on back of frame or object and press firmly. Repeat with each set of strips. Remove remaining liners. 4. Position frame or object on wall and press firmly for 30 seconds. 5. Grab item at bottom and gently peel off surface. Do not pull straight toward you to remove. Wait one hour to achieve maximum holding strength. 6. Mount item by pressing fasteners firmly together until they snap. If picture is not level, reposition as necessary. Recommended Replacement: When using multiple sets, use one set per 3 lbs (1.4 kg). Do not hang objects over 10 lbs (4.5 kg). To Remove: 1. Grab item at bottom and gently peel off surface. Do not pull straight toward you to remove. Do not peel the fastener off. Never pull the tab out oat an angle. Tab could break or damage surface. 2. To prevent fastener from snapping your fingers, lightly press top of strip. 3. Slowly slide the tab straight against the surface, stretching at least 12 inches until the fastener releases. Repeat steps for other fasteners. Note: Apply to surfaces above 50 degrees F (10 degrees C). Adhesive could soften and lose adhesion above 105 degrees F (40 degrees C).
3M Construction & Home Improvement Markets Div.
St. Paul, MN 55144-1000
Not recommended for wallpaper. Do not use for heirlooms or other irreplaceable items. Do not hang objects over beds.